Poster Number 308
See more from this Division: S06 Soil & Water Management & ConservationSee more from this Session: Supporting Ecosystem Services with Conservation Agriculture: II
This study was conducted on seven Iowa State University Research and Demonstration Farms starting in 2002, and continuing to the present. Treatments include five tillage systems (no-till, strip-tillage, chisel plow, deep ripper, and moldboard plow) and three crop rotations of corn-corn-soybean, corn-soybean, and corn-corn across the five tillage systems and several soil associations. Baseline soil samples were collected in 2002 prior to implementing the tillage treatments. Soil samples were periodically collected for each site, with the most recent samples taken in 2010. The soil samples were collected from all sites for depths of 0-6, 6-12, 12-18, and 18-24 inches and were analyzed for total carbon, total nitrogen, and bulk density. Grain yield was also collected yearly for each tillage treatment and rotation. The experimental design was a randomized complete block design with four replications.
Regardless of the crop rotation, average corn yields from across the state show that both strip-tillage and conventional tillage generally over preformed no-till. However, the amount of difference in yields between tillage treatments depends on the soil and drainage conditions of the site. Comparing the corn yield of each tillage system shows that second year corn in a C-C-S rotation was lower than that for corn after soybean in all tillage systems. Soybean yields are affected by yearly variability within all tillage systems, but no differences in yield were observed between tillage systems within each year. The lack of significant soybean yield differences between different tillage systems was observed at all sites across the state.
See more from this Session: Supporting Ecosystem Services with Conservation Agriculture: II